Passenger diesel train DR1A for Beamng Drive. The mod comes with a carriage. To install, simply drag the downloaded mod into the Mods folder.

• If you have problems with braking, you should drive in realistic mode (press q) and brake in N gear, I still haven't figured out how to fix this problem, but at least it's playable this way
• 12 configurations, 6 liveries. The first 6 configurations have the "Front Engine" prefix at the beginning, these are the main DR1A trains and should be placed at the front of the train, the rest of the configurations with the "Rear Engine" prefix are the rear trains and are placed at the end of the train, their only difference is that they have different couplings.
• Fully working headlights, you can switch the headlights and main spotlight separately
• Moving wheels
• Properly placed exhaust
• Good drives
• The carriage has seats with collision, you can walk around the carriage in walking mode.
• To assemble a train, select DR1A with the Front Engine prefix and place it at the beginning of the train, then create cars. You can create one car and place it on the tracks using the editor on F11. Once you place the first car on the tracks, you can duplicate it by holding Shift and dragging the car in the direction you want, then create a DR1A with the Rear Engine prefix. Switch to the first train and press L, making sure the cars are not stuck in the tracks by lifting them up slightly. Then switch to the first hooked car, open the radial menu, then click Trailers > "Hook all". If the rear diesel train cannot be coupled, then move closer to the car, release the brakes and switch back to the last coupled car and click "Connect All"

(lighting control is different from my other mods.) Control DR1A: T

• accelerate and press WG
• decelerate and press SL near the speedometer
• move straight H near the speedometer
• move backward Alt + A
• change direction H
• horn K
• turn on the headlights I
• turn on the main projector [
• turn on the right rear light]
• turn on the three rear lights Y
• interior lighting

Car control DR1A:Y

• interior lighting

If the train is not moving, make sure it is not stuck in the tracks, press f11 and lift it up slightly, if the train is still not moving, release the air brakes (down arrow) and independent brakes (P/spacebar) and shift into m1.

Known Issues: Poor driver's cabin quality, doors not opening, interior lights must be turned on separately in each carriage, interior lights come through the floor and illuminate the rails below, DR1A engine has no seat collision, mod is quite performance intensive, expect lag if you connect too many carriages. In the future I plan to replace the cabin with a better one, improve the sounds and improve the Latvian and Lithuanian Railway liveries expensive

Mod author:zlodikan