Automatic Tramline System 1.6.0

1.5.0.0:
- Ridgemarkers auto mode fixed — switching sequence now works correctly, previously it did not switch at one with an odd number of lanes.
- For some Sowingmachine the auto mode has been fixed in general, as it was partially not switching at all.
- New key added where you can now trigger a Tramline at any time in any mode with a key press — however ATTENTION this must also be deactivated again via the key, as it overrides all modes.

1.4.0.0:
- Save on dedicated servers adjusted: the HUD position, GPS reference line and the half-side deactivation are now saved correctly.
- Two new rows added to set the position of the track lane behind the seed drill (accessed via the gear icon).
- On the Alpego DMAX 800 + Rubber Seeding Units, the track lane is now created centered by default.
- Ridgemarkers can now be controlled with 5 different modes (accessed via the gear icon).
- Pre-emergence marking can now be deactivated so that Tramlines are only visible from the first growth stage onwards.
- Help pages updated for the new settings.

The HUD is now also displayed when the seed drill is not selected.
An additional row has been added where you can set the lane width for maps with more ground angles where the grid is smaller.